A4988 Stepper Motor Driver Module
-
Supports full-step, half-step, and microstepping modes
-
Adjustable current limiting via onboard potentiometer
-
Built-in thermal shutdown and overcurrent protection
-
Compatible with common stepper motors (e.g., NEMA 17)
-
Simple STEP and DIR interface for microcontrollers
-
Compact design ideal for embedded systems
-
Low heat generation with efficient operation
-
Drop-in compatible with many popular driver boards
DRV 8825 with heatsink
-
Based on DRV8825 high-performance stepper driver IC
-
Supports up to 1/32 microstepping for ultra-smooth motion
-
Higher voltage range compared to common drivers
-
Adjustable current limiting for motor protection
-
Integrated overcurrent and thermal shutdown protection
-
Included aluminum heatsink for improved heat dissipation
Easy Driver stepper motor driver
-
Based on A3967 microstepping driver IC
-
Supports full-step and microstepping operation (up to 1/8 step)
-
Adjustable motor current via onboard potentiometer
-
Wide input voltage range for motor power
-
STEP and DIR control interface for easy integration
-
Built-in protection against overcurrent and overheating
L293D Mini Motor Driver Module
-
Compact L293D motor driver module for easy integration into circuits
-
Dual H-Bridge design to control two DC motors independently
-
Supports bidirectional motor control (forward and reverse)
-
Compatible with Arduino, Raspberry Pi, and other microcontrollers
-
Built-in protection diodes for inductive loads
L298 Motor Driver H-Bridge
-
Dual H-Bridge motor driver for controlling two DC motors simultaneously
-
Supports bidirectional motor control (forward and reverse)
-
Compatible with Arduino, Raspberry Pi, and other microcontrollers
-
Handles higher current loads than typical microcontroller pins
-
Built-in thermal shutdown protection and clamp diodes for motor safety
L298 Motor Driver H-bridge SMD (small)
-
Small SMD version of the L298 dual H-Bridge motor driver
-
Supports two DC motors or one stepper motor
-
Bidirectional motor control (forward and reverse)
-
Compatible with Arduino, Raspberry Pi, and other microcontrollers
-
Allows PWM-based speed control
-
Compact size suitable for miniaturized projects and tight PCBs
PCA9685 16 Channel Servo Motor Driver
- 16 channel servo motor driver power supply is 5V compliant and still talks to a 3.3V microcontroller.
- this motor driver contains 6 address select pins.
- these address pins are used for configuring up to 62 ICs on a single I2C bus.
- this motor driver has an adjustable PWM frequency of up to 1.6KHz almost.
- this driver has a 12-bits frequency resolution.
Quadcopter Esc 30A (Electronic Speed Controller)
-
30A continuous current rating for stable motor control
-
Supports brushless DC motors commonly used in quadcopters
-
Smooth acceleration and deceleration for precise flight control
-
Compact and lightweight design suitable for drone applications
-
Overcurrent, overheat, and low-voltage protection for safe operation
ULN2003 5V Stepper Motor Driver Module
- Stepper Motor Operating Voltage: 5V
- Stepper Motor Diameter: 28mm
- Step angle: 5.625 x 1 / 64
- Reduction ratio: 1 / 64
- Self-positioning torque: >34.3mN.m
- Motor Coil DCR: 200ohm +/- 7% (25’C)
- 5 Line 4 phase stepper motor is driven by ULN2003 chip
- Stepper motor supports easy and direct plugin to driver board
- Â A, B, C, D four-phase LED indicators indicate the status of the stepper motor