Easy Driver stepper motor driver
-
Based on A3967 microstepping driver IC
-
Supports full-step and microstepping operation (up to 1/8 step)
-
Adjustable motor current via onboard potentiometer
-
Wide input voltage range for motor power
-
STEP and DIR control interface for easy integration
-
Built-in protection against overcurrent and overheating
L293D Mini Motor Driver Module
-
Compact L293D motor driver module for easy integration into circuits
-
Dual H-Bridge design to control two DC motors independently
-
Supports bidirectional motor control (forward and reverse)
-
Compatible with Arduino, Raspberry Pi, and other microcontrollers
-
Built-in protection diodes for inductive loads
L298 Motor Driver H-Bridge
-
Dual H-Bridge motor driver for controlling two DC motors simultaneously
-
Supports bidirectional motor control (forward and reverse)
-
Compatible with Arduino, Raspberry Pi, and other microcontrollers
-
Handles higher current loads than typical microcontroller pins
-
Built-in thermal shutdown protection and clamp diodes for motor safety
PCA9685 16 Channel Servo Motor Driver
- 16 channel servo motor driver power supply is 5V compliant and still talks to a 3.3V microcontroller.
- this motor driver contains 6 address select pins.
- these address pins are used for configuring up to 62 ICs on a single I2C bus.
- this motor driver has an adjustable PWM frequency of up to 1.6KHz almost.
- this driver has a 12-bits frequency resolution.
ULN2003 5V Stepper Motor Driver Module
- Stepper Motor Operating Voltage: 5V
- Stepper Motor Diameter: 28mm
- Step angle: 5.625 x 1 / 64
- Reduction ratio: 1 / 64
- Self-positioning torque: >34.3mN.m
- Motor Coil DCR: 200ohm +/- 7% (25’C)
- 5 Line 4 phase stepper motor is driven by ULN2003 chip
- Stepper motor supports easy and direct plugin to driver board
- Â A, B, C, D four-phase LED indicators indicate the status of the stepper motor